Lithofin MN COLOUR INTENSIFIER is a ready to use siloxane impregnator which is solvent based and contains special colour intensifying components.
Lithofin MN COLOUR INTENSIFIER penetrates into the surface rendering it water repellent while at the same time intensifying the colour without producing any gloss. Surfaces appear more colourful and fresh – “wet effect”. The water resistance reduces the sensitivity of the surface, largely preventing staining and facilitating maintenance. Lithofin MN COLOUR INTENSIFIER does not form any layers, thereby maintaining the surface’s water permeability.
For adding lustre to wall and floor surfaces, stairs, entrance areas, terraces, etc. which appear bland and colourless. Suitable for indoor and outdoor use. Surfaces: all absorbent, porous natural stones (e.g. granite, gneiss, porphyr, marble, limestone, slate, etc.) and engineered stones with rough, sawn, honed and flamed surfaces.
Directions for use:
The surface to be treated must be completely dry and clean. Always try the product in an inconspicuous area prior to use. Finally, evenly apply a consistent amount of Lithofin MN Colour Intensifier with a clean brush, a roller or a cloth.
Please note: on highly absorbent surfaces, this procedure may have to be repeated after five minutes. The product should saturate the stone without drying on the surface. Less absorbent surfaces may have to be towelled off.
Drying Time: Safe to walk on after approx. 30 minutes, completely dry after 24 hours.
Coverage: Approx. 10m² per litre depending on the surface.