Lithofin STAIN STOP has been specifically designed for marble, natural and engineered stone. It uses a high quality combination of water and oil resistant components based on alkoxysilanes.
Lithofin MN STAIN STOP penetrates into the surface and coats the capillaries with an extremely thin, invisible film. Oil, grease and water are not absorbed by the surface, but remain on the surface, therefore oil and dirt can be easily removed without leaving stains.
The effectiveness depends on the amount of product absorbed by the surface. the appearance of the natural stone is not affected.
Lithofin MN STAIN STOP forms an invisible protective film to protect against staining and to facilitate maintenance of natural stone surfaces. Perfect for use on wall and floor surfaces in the kitchen and bathroom.
Directions for use:
The surface to be treated must be clean and completely dry. Working in small areas (5-10m2) apply product generously and evenly using a sponge, roller or brush until the surface appears wet. Keep wet for between 5-15 minutes ensuring even distribution. Finally, completely remove all the excess. Do not allow to dry on the surface if not being absorbed into the stone. Lithofin MN STAIN STOP should also be applied in temperatures of between 10c and 25c.
After 30-40 minutes the surface will be dry and ready to be stepped on. Complete drying process and effectiveness of the impregnation will take approx 5 days.
Coverage:
- Approx 12-25m2 per litre on polished surfaces
- Approx 5-7m2 per litre on rough or honed surfaces
- Approx 3-6m2 per litre on porous sandstone